Quadra-Fire 810-03201 Bedienungshandbuch PDF herunterladen (Seite 23)

January 28, 2010

250-7251H

Page 

Castile Pellet Insert

1. A 1 volt AC thermostat is required to operate this

pellet appliance. You may use the included wall mount

thermostat or purchase an optional programmable

thermostat or remote control. The included thermostat

is equipped with an adjustable heat anticipator. The

current rating is .05 amps. The anticipator needs to

be adjusted to the lowest setting available.

. When mounting a thermostat on a wall, be sure to follow

your thermostat installation instructions carefully.

NOTE: Thermostat must be mounted level for accu-

rate readings. The thermostat should be mounted

on an inside wall and not in direct line with the

appliance convection air. Remove any packaging

from inside the thermostat before using.

NOTE: If the thermostat is located too close to

the appliance, you may need to set the tempera-

ture setting slightly higher to maintain the desired

temperature in your home.

. There is a 4 screw terminal block located on the junc-

tion box to the left of the power cord inlet. The center

 screws are for the thermostat wires. The outer  are

the mounting screws for the terminal block. Figure

23.1.

H. Thermostat Installation

Figure 23.1

Shock hazard.

• Do NOT remove grounding prong from plug.

• Plug directly into properly grounded  prong

receptacle.

• Route cord away from appliance.

•

Do NOT route cord under or in front of appli-

ance.

CAUTION

Control Box

Junction Box

Reset Button

Heat Output

Switch

Power Cord

Outlet

Thermostat

Block

Fuse

Red Call

Light

Red/Green/Amber Light

Blue Light

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Quadra-Fire 810-03201 Bedienungshandbuch Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Quadra-Fire 810-03201